solar charge controller from juta solar
1. Product Introduction
This intelligent,multi-purpose solar charge and discharge controller has a very friendly interface of fixed LCD display.Various control parameters can be flexibly set,fully meet your various application requirements. It has following features:
●Vivid LCD graphic symbols
|
●Intelligent PWM charging mode
|
●Simple button operation
|
●Settable Operating mode of Load
|
●Automatic Identification of System Voltage level
|
●Battery Low-voltage protection
|
●Adjustable control parameters
|
●Over-current protection
|
●Battery reverse-discharge protection
|
●USB Power Output(optional)
|
●Battery reverse-connected protection
2. Installation
2.1 Ready tools and cables, right cables are recommended. Ensuring that the current density <4A/mm2, Which is conductive to reducing the line voltage drop. Recommended:20A with 6mm2 cable. Check whether the installation sites compliance with the relevant safety requirements. Please avoid using or installing the controller in damp,dusty places or places with flammable,explosive and corrosive gases.
2.2 The controller is fixed to the vertical plane. In order to ensure good heat dissipation conditions of the controller, the controller please beneath the reserved space above 10cm.
2.3 To connect the controller and the battery by cables with right polarity. The LCD of controller will be on if successfully connected,otherwise,to check and reconnect.
2.4 To connect the solar panel and the controller by cables with right polarity. If there is sunshine and is correctly connected,the solar icon will be on, otherwise,to check and reconnect .
2.5 To connect your load and the controller with right polarity. Pay attention to + - polarity to avoid reversed connection, otherwise, your load may be damaged. Demolition: In case of any accident, please disconnect the solar panel, battery and load with controller in order.
|
评论
发表评论